https://doi.org/10.1140/epjs/s11734-025-01927-y
Regular Article
The effect of staging of fluidic oscillation on microbubble generation in viscous liquids
1
Perlemax Ltd., 318 Broad Lane, S3 7HQ, Sheffield, UK
2
School of Chemical Engineering and Analytical Science, The Mill, University of Manchester, M13 9PL, Manchester, UK
3
Department of Materials Science and Nanoengineering (MSN), Mohammed VI Polytechnic University (UM6P), Lot 660-Hay Moulay Rachid, 43150, Ben Guerir, Morocco
4
School of Chemical, Materials and Biological Engineering, University of Sheffield, Mappin Street, S1 3JD, Sheffield, UK
a
This email address is being protected from spambots. You need JavaScript enabled to view it.
Received:
25
August
2025
Accepted:
4
September
2025
Published online:
24
September
2025
Abstract
Microbubbles are broadly defined as gas–liquid interfaces smaller than 1 mm and larger than 1 μm. Conventional modes of microbubble generation (ultrasound, ablative technologies, and electrolytic mechanisms) requires large amounts of energy and generate a wide distribution of microbubbles. Fluidic oscillation is an energy-efficient technique used for microbubble generation capable of generating a fairly monodisperse population of microbubbles compared to conventional bubbling. This study hypothesises that partial liquid wetting of membrane pores further benefits microbubble production. The partial liquid wetting can be introduced by utilising the ‘off’ portion of the fluidic oscillator, resulting in liquid imbibition. This liquid imbibition temporarily changes the membrane dynamics with intrapore wetting by the liquid. Therefore, using steady flow immediately after this operation would result in a similar behaviour (smaller bubble size) temporarily. This results in an interesting interplay between the two conditions—conventional bubbling (steady flow) and oscillatory flow, thereby presenting an intermediate condition with an associated reduction in bubble size when staged appropriately, i.e., for steady flow bubbling post-fluidic oscillator application. The resultant average bubble size is 25% lower than the steady flow bubbling prior to fluidic oscillation application but is dependent on physico-chemical properties: primarily viscosity and wetting angle. An intermediary condition is set based on the staging resulting in a 25–50% reduction in bubble size from steady-flow dynamics post-application of the oscillatory flow.
This paper is dedicated to the memory of Professor Etienne Guyon.
Supplementary Information The online version contains supplementary material available at https://doi.org/10.1140/epjs/s11734-025-01927-y.
© The Author(s) 2025
Open Access This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. The images or other third party material in this article are included in the article's Creative Commons licence, unless indicated otherwise in a credit line to the material. If material is not included in the article's Creative Commons licence and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder. To view a copy of this licence, visit http://creativecommons.org/licenses/by/4.0/.
